ZTS600 | 154Check & Calibrate
5. If the center of the laser dot makes a clearly circular movement, or moves
more than 3 mm away from the point which was first marked, an adjust-
ment may be required. Call your nearest GeoMax service department.
Depending on brightness and surface type, the size of the laser dot can
vary. At a height of 1.5 m an average diameter of 2.5 mm is estimated.
11.6 Servicing the Tripod
Service the
tripod step-by-
step
The maximum diameter of the circular movement described by
the center of the laser dot should not exceed 3 mm at a height of
1.5 m.
The connections between metal and timber components must
always be firm and tight.
1
2
3
To Next Page
Loading...
