Need help?Do you have a question about the GeoMax Zenith40 GNSS Series and is the answer not in the manual?
General| Brand | GeoMax |
|---|---|
| Model | Zenith40 GNSS Series |
| Category | Measuring Instruments |
| Language | English |
Download and store firmware files onto the provided MicroSD card.
Charge the ZBA201 batteries using the ZCH201 charger until the FULL indicator flashes.
Install USB drivers and connect the receiver to the PC.
Install Zenith Manager software and connect the receiver via USB or Bluetooth.
Verify the installed firmware version of the GNSS receiver using Zenith Manager.
Configure the Zenith40 receiver settings for RTK operation.
Configure internal UHF radio settings based on country licence requirements.
Configure internal GPRS settings, including SIM card and NTRIP credentials.
Manage and add GNSS antennas using the Zenith Manager software.
Install optional receiver licenses using a NovAtel licence key file.
Safely disconnect the Zenith40 receiver from the PC after configuration is complete.
Set up the Zenith40 as an RTK rover on a pole for field use.
Set up the Zenith40 as a base station for transmitting RTK corrections.
To Next Page