GeoMax Zenith40 GNSS Series - Default Chapter; Table of Contents

Zenith40 GNSS Series
- 2 -
Installation Guide © 2019 GeoMax AG, Widnau Switzerland
Table of Contents
1 I
NTRODUCTION
.............................................................................. 3
2 G
ENERAL
P
REPARATION
.................................................................. 3
2.1 Copy Zenith40 Firmware on MicroSD card ................................................... 3
2.2 Battery Charging.......................................................................................... 3
2.2.1 Zenith40 receiver 3
3 P
REPARATION OF THE
GNSS
RECEIVER
............................................. 3
3.1 Connecting to the PC ................................................................................... 3
3.2 Receiver connection with Zenith Manager .................................................... 5
3.2.1 Installation of Zenith Manager 5
3.3 Checking the receiver firmware version ...................................................... 6
3.4 Receiver configuration ................................................................................ 8
3.4.1 Changing the UHF radio settings 9
3.4.2 Changing the GPRS settings 11
3.5 Antenna Management ................................................................................ 12
3.6 Installation of licences ............................................................................... 14
3.7 Disconnecting from the PC ......................................................................... 15
4 E
QUIPMENT SETUP
....................................................................... 16
4.1 Rover setup ............................................................................................... 16
4.2 Base setup ................................................................................................. 17