Zenith40 GNSS Series
- 9 -
Installation Guide © 2019 GeoMax AG, Widnau Switzerland
3.4.1 Changing the UHF radio settings
To meet country radio licence requirements, the internal UHF radio must be set before use
to legally allowed local frequencies as defined by local or governmental authorities. Use of
forbidden frequencies may lead to prosecution and penalties.
The following procedure defines the configuration of the internal UHF radio. After choosing
in the GNSS configuration panel the receiver as a base or as a rover and selecting the
internal radio configuration, the settings for the internal radio will be displayed. Up to 15
different frequencies can be set. A choice of required frequencies can be entered into the
channel table. Check with your country specific local authorities, what frequencies and
channel spacing may be used. At the Radio Settings field the internal radio can be
configured with default channel, protocol type, channel spacing, transmission power and
correction format.
To Next Page
Loading...
Need help?
General
