EasyManuals Logo

GeoMax Zenith40 GNSS Series User Manual

GeoMax Zenith40 GNSS Series
17 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
Zenith40 GNSS Series
- 16 -
Installation Guide © 2019 GeoMax AG, Widnau Switzerland
4 E
QUIPMENT SETUP
4.1 R
OVER SETUP
For a RTK rover, the Zenith40 equipment can be setup on a pole as shown above.
When working with the UHF radio, ensure the correct frequency and protocol are set as
described in section 3.5. Attach a radio antenna suitable for the set frequency. The following
UHF antennas can be ordered from GeoMax:

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GeoMax Zenith40 GNSS Series and is the answer not in the manual?

GeoMax Zenith40 GNSS Series Specifications

General IconGeneral
BrandGeoMax
ModelZenith40 GNSS Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals