GeoMax Zenith40 GNSS Series User Manual

Zenith40 GNSS Series
- 12 -
Installation Guide © 2019 GeoMax AG, Widnau Switzerland
3.5 A
NTENNA
M
ANAGEMENT
All available GeoMax GNSS antennas are currently supported in the antenna management
by default. If your Base-Rover set up will include a non GeoMax device, you should make
sure the base antenna is recognised on the Zenith40. To do that, it’s needed to add this
specific antenna manually with the Zenith Manager. See how to do it below:
With the receiver connected to Manager, select Antenna from the bottom menu.

GeoMax Zenith40 GNSS Series Specifications

General

Brand	GeoMax
Model	Zenith40 GNSS Series
Category	Measuring Instruments
Language	English