Geotech G110 - Instrument Status Icons; Entering Data

Page 15 of 48
Operating Manual
www.geotechuk.com
OMG100N Iss.02
© QED Environmental Systems Ltd.
G 1 0 0 R A N G E
Instrument Status Icons
The following icons may be displayed on the instrument read screens:
Icon
Description
Battery charge state
(flashing)
< 1 hour remaining
(flashing)
Battery charging
Charged
Pump running
(flashing)
Pump stalled (Backlight turns red)
Alarm set
(flashing)
Alarm active (Backlight turns red)
USB connected to PC (flickers when transferring data)
Logging mode active (flashes when memory nearly full)
Temperature probe(s) connected
Humidity probe connected
(flashing)
Service due (every 12 months)
Service overdue
Fault/repair
Waiting
Note: A red backlight is displayed if the pump is stalled or the alarm is activated. For further
information, please refer to the Alarms or Flow Fail sections.
Entering Data
During normal operation the user may be prompted to enter data or information via the keypad, i.e.
entering an ID code or setting an alarm level.
When entering data into the instrument all fields are fixed format and are populated from the right.
For example, to enter a new time 09:25:00 the user would type in 092500 using the numeric keypad
in the following sequence:-
* : : 0
* : :09
* : 0:92
* :09:25
* 0:92:50
* 09:25:00
Press the ‘Enter’ key to confirm/accept data keyed.
Any mistakes can be corrected using the soft-key ‘Delete’ which will delete the last character typed.
Alternatively, the sequence can be re-typed before the ‘Enter’ key is pressed and the existing
numbers will be pushed off the screen.
Note: The instrument will not allow invalid data to be entered; this should be deleted and re-
entered.