Screen 2 - Information
Utilities
The ‘Utilities’ option enables the operator to configure instrument settings prior to taking readings.
From the ‘Main Read Screen’ press the ‘Menu’ key on the instrument panel.
Press ‘Key 2’ to display the ‘Utilities’ menu and the following screen is displayed:
Screen 3 - Utilities menu
Time & Date
The ‘Time and Date’ option enables the operator to check or set the instrument’s internal clock. The
current time/date are appended to every stored reading.
From the ‘Main Read Screen’ press the ‘Menu’ key on the instrument panel.
Press ‘Key 2’ to display the ‘Utilities’ menu.
Press ‘Key 1 – Time & Date’ and the ‘Set Time & Date’ menu is displayed:
Screen 4 - Set time & date
Press ‘Key 1’ to change the time or press ‘Key 2’ to change the date. Type the time or date
using the numeric keypad followed by the ‘Enter’ key. The instrument will not allow invalid
times or dates to be entered.
Note: The clock will need to be manually adjusted to cope with daylight saving changes or
To Next Page
Loading...
