Geotech G110 - Calibration; View Data

Page 23 of 48
Operating Manual
www.geotechuk.com
OMG100N Iss.02
© QED Environmental Systems Ltd.
G 1 0 0 R A N G E
Calibration
The G100 range of instruments is fully calibrated during manufacture and when returned for service.
However, to improve accuracy between services a user/field calibration can be performed.
Note: For further information please refer to Calibration of this manual.
View Data
The ‘View Data’ option enables the operator to view the stored readings.
From the ‘Main Read Screen’ press the ‘Menu’ key on the instrument panel.
Press ‘Key 4’ to view stored data readings and the following screens are displayed:
Screen 10 - View data 1
Screen 11 - View data 2
Press ‘Key 4 - Scroll Left’ and ‘Key 6 - Scroll Right’ to move through the stored readings either
forwards or backwards. Press ‘Key 2 - Scroll Up’ and ‘Key 8 - Scroll Down’ to switch between the
first (CO
2
, O
2
& Baro) and second (T
1
, T
2
& humidity) group of reading parameters.
Press the soft-key ‘More’ to refine or filter the readings to view.
Screen 12 - Soft-key 'More'

1 – Delete All: Enables the operator to delete all the readings stored

2 – Filter: Used to refine/filter the range of readings displayed by ID or date ranges. Press
between two dates, after a date, before a date or all dates.

3 – Go to: Enables the operator to jump to the first or last reading in the memory or any other
reading.