Page 47 of 48
Operating Manual
OMG100N Iss.02
© QED Environmental Systems Ltd.
Clear plastic tubing used to route gases from the
exhaust port.
Default calibration settings preset at time of factory
calibration.
Firmware is the name given to the analyser’s internal
software. This can be programmed using the re-flash
command on the Analyser Data Manager software.
The latest software release can be downloaded from
the QED website. It is also automatically updated
when the analyser is returned for servicing.
Analyser Data Manager software enables the user to
maximise the operation of the incubator analyser.
Instrument readings and event log data may be
downloaded to a PC for further analysis and exported
to other applications such as MS Excel.
Displayed throughout the documentation with a
warning symbol. Warning information may affect the
safety of users.
Port located on the top of the analyser to which the
inlet tube is attached.
Liquid Crystal Display. Fitted to the front panel of the
analyser.
The main analyser screen for normal operations and
all operations are carried out from this screen.
The analyser memory should not be used as a
permanent storage medium and data collected should
be transferred using the Analyser Data Manager
software.
Device used to remove water vapour from the sample
gas. This is located at the back of the analyser and
should not be covered or partially covered. This is not
user serviceable and should NOT be removed by the
user.
Device to remove condensed water from the sample
line. This can be a simple absorption filter as per a
moisture trap, a catch-pot or simple return tube
depending on the application.
Oxygen gas typically 20.9% in air, measured via
electro-chemical cell.
Over range codes are errors above the maximum
allowed reading and will be displayed with more than
chevrons (>>.>)
To Next Page
Loading...
