Administrator Mode
103
4 4
4.3 I/O Settings
Note the I/O settings are only available for Box Camera, Bullet Camera,
Ultra Bullet Camera, PTZ Camera, PT Camera, Vandal Proof IP Dome,
and Fixed IP Dome.
After installing the I/O device, you need to enable the I/O settings on the
camera. For how to install the I/O device on the camera, see the following
reference sections in the corresponding Hardware Manual:
GV-IPCAM Reference section
Box Camera I/O Terminal Block
Bullet Camera
Connecting the Camera
Connecting the Camera
PTZ Camera I/O Terminal Block
PT Camera I/O Terminal Block
Vandal Proof IP Dome Connecting the Camera
Fixed IP Dome I/O Terminal Block
To Next Page
Loading...
Need help?
General
