Administrator Mode
119
4 4
To enable connection to GV-Backup Center:
1. Activate Link: Enable the connection to the GV-Backup Center.
2. Host Name or IP Address: Type the host name or IP address of the
GV-Backup Center.
3. Port Number: Match the communication port on the GV-Backup
Center or keep the default value 30000.
4. User Name: Type a valid user name to log into the GV-Backup
Center.
5. Password: Type a valid password to log into the GV-Backup Center.
6. Backup Video: Select the streams to back up their recordings to the
GV-Backup Center.
7. Compact Video: Select the streams to only back up their Key Frames
to the GV-Backup Center, instead of full recordings. This option is
useful to save the backup time.
8. Resend all files: Select this option to send all the recorded files that
have received by the Backup Center again.
9. Enable Schedule Mode: Enable the GV-Backup Center connection
on the schedule you set in the Select Schedule Time section. Refer to
4.6 Recording Schedule for the same settings.
10. Click Apply. The Connection Status should display “Connected” and
connected time.
If you have a failover GV-Backup Center server which provides
uninterrupted backup services in case the first GV-Backup Center failed,
configure the failover GV-Backup Center as below.
1. Automatic Failover Support: Enable the automatic connection to the
failover GV-Backup Center once the connection between camera and
the first GV-Backup Center is interrupted.
To Next Page
Loading...
Need help?
General
