Administrator Mode
165
4 4
[Host Settings] Enter a descriptive name for the camera.
[Auto Reboot Setup] Select Enable to activate automatic reboot and
specify the time for reboot in the sub fields.
Day Interval: Type the day interval between each reboot.
Reboot Time: Use the drop-down lists to specify the time for
automatic reboot.
[Repair Record Database] Note this function is not available for Target
Series. Click Apply to repair the database when errors occur while playing
back the recordings with the Remote ViewLog player. Problems can occur
when there are errors in firmware or damages to the micro SD card.
[Database Status] Note this function is not available for Target Series.
Displays the repairing status of database.
[Firmware Update] This field displays the firmware version of the camera.
[System Settings]
Load Default: Clicking the Load Default button to restore factory
default settings. After applying the default settings configure the
camera’s network setting again.
Load Default Without Network: Clicking the Load Default without
Network button to restore factory default settings without changing
the camera’s network settings.
[Temperature Status] Note this function is not available for Target Series
(except for GV-EFD2101/3101/5101, GV-EVD2100/3100/5100 and GV-
EBL5101), Cube Camera and Advanced Cube Camera. Displays the
current chipset temperature inside the camera.
To Next Page
Loading...
Need help?
General
