Gesipa FireBird Pro - 5.5 Environmental Protection; 6. Troubleshooting Common Issues; 6.1 Nut Does Not Screw On; 6.2 Nut Is Not Screwed Off

31
GB
5.5 Environmental protection
If batteries need to be replaced, please observe the following:
• Take used GESIPA
®
batteries back to your agent or to GESIPA
®
for recycling.
• Never throw discarded batteries into the waste, into re or into water!
6. Troubleshooting
6.1 Blind rivet nut does not screw on
Cause Corrective measures
Nut thread defective Use new nut
Threaded mandrel defective Change threaded mandrel (Point 3.1)
Nut does not rest against nosepiece Threaded mandrel length x incorrect; adapt to nut
length (see point 3.2)
Nut unscrew again Keep switch 9 pressed until the tool stops (Point
4.1)
No battery
Error indicator on the display E4
Charge battery (Point 5.3)
6.2 Nut is not screwed off
Cause Corrective measures
Nut thread deformed/destroyed due to excessive
setting force
Error indicator on the display E3
Reduce setting force (Section 3.3); remove using
hexagon screwdriver (Section 4.2; see Fig. 5)
6.3 Set blind rivet nut is loose
Cause Corrective measures
Setting force too low Dene setting force correctly (Section 3.3)
Switch released before the dened setting force
is reached.
Riveting is faulty!
Error indicator on the display: E1
Execute setting sequence correctly (Section 4.3)