26
Using the Tether (Optional)
You can purchase a stylus and tether for your computer model. Use the
tether to attach the stylus to the computer.
1. Thread one of the tether’s loop through the hole of the stylus (
), tie a
dead knot at the end (
), and pull the tether (
) so that the knot fills
in the hole and prevents the tether from falling off.
2. Insert the other loop to the tether hole on the computer (
). Then,
insert the stylus through the loop (
) and pull it tight.
3. When not in use, store the stylus in the stylus slot.
To Next Page
Loading...
