Getac B360 User Manual

42
Replacing the Battery Pack
CAUTION:
 There is danger of explosion if the battery is incorrectly replaced. Replace
the battery only with the computer manufacturer’s optional battery packs.
Discard used batteries according to the dealer’s instructions.
 Do not attempt to disassemble the battery pack.
NOTE: The illustrations show the Standard model as the example. The removal
and installation method for the Expansion model is the same.
1. Turn off the computer and disconnect the AC adapter.
Skip this step if you are hot swapping the battery pack.
2. Carefully place the computer upside down.
3. Locate the battery pack you want to remove ( or ).
4. Slide the battery latch toward the right (

) and then upwards (

) to
release the battery pack.
5. Remove the battery pack from its compartment.
6. Fit another battery pack into place. With the battery pack correctly
oriented, attach its connector side to the battery compartment at an
angle (

) and then press down the other side (

).

Getac B360 Specifications

General

CPU configuration (max)	1
Intel Flex Memory Access	Yes
Intel Trusted Execution Technology	No
Configurable TDP-up	25 W
Configurable TDP-down	10 W
Configurable TDP-up frequency	2.1 GHz
Configurable TDP-down frequency	0.8 GHz
SSD capacity	The Solid State Drive's storage capacity in Gigabytes.
Card reader integrated	-
Total storage capacity	256 GB
USB 3.2 Gen 2 (3.1 Gen 2) Type-A ports quantity	2
Internal memory	8 GB
Keyboard language	German