Getac UX10G3 - Using the Tether

5
Using the Tether
A tether is provided for attaching the stylus to your Tablet PC.
1. Insert one of the tether’s loop ends through the hole of the stylus (as
indicated by

below). Then, insert the other end through the first loop
(as indicated by

below) and pull it tight.
2. Insert the other loop end to the tether hole on the Tablet PC (as indicated
by

below). Then, insert the stylus end through the loop (as indicated
by

below) and pull it tight.
NOTE: If the hard handle is installed, attach the tether to the D-ring on the
hard handle.