<Doc_USR><Doc_502607400><Rel_A><Lang_GB>
Page 20 of 28
Alarms
If the red lamp at O lights up, the process has been aborted because of a fault. The dis-
play shows a fault code.
Acknowledging a fault code
Acknowledge the fault code as follows:
Note the fault code
Cancel the acoustic signal by pressing U. The machine remains locked but the
program has been stopped. The display shows the password entry menu.
Correct the fault or call service personnel.
Enter the password (558387) using the arrow keys and press S. All liquid is drai-
ned from the machine and the soiled-side door is unlocked*.
Open the door and remove the items.
The items in the machine are not clean and must be washed again from the
beginning with a new program.
If the items are still hot, handle them with care to avoid burns.
* If the drain pump is faulty, water cannot be drained from the machine and the fault cannot be put right
until the door has been opened. The soiled-side door is unlocked as soon as the password is confirmed.
Fault codes in the machine
Fault codes indicate that a serious fault has occurred in the machine or the washing pro-
cess. The fault must be put right by an authorized service technician.
The following fault codes may occur:
•
•
•
•
•
F01
Fault code Description
F00 Power failure
F01 The motor cutout has tripped.
F02 Water lling takes more than 10 minutes.
F03 Draining takes longer than ve minutes or there is water remaining
in the washing chamber at the end of the draining phase.
F04 Water leakage in the dryer.
F05 The soiled-side door does not lock within 10 seconds of program
start or if the door is opened while a program is running.
F06 The soiled-side door does not unlock within 10 seconds.
F09 The clean-side door does not close within 10 seconds of program
start or if the door is opened while a program is running.
A09 The soiled-side door does not open within 20 seconds of the pro-
gram ending.
F10 The soiled-side door does not unlock within 10 seconds..
To Next Page
Loading...
Need help?
General
