Getinge 86 SERIES User Manual

<Doc_USR><Doc_502607400><Rel_A><Lang_GB>
Page 22 of 28
Fault codes in the master supervisory system (option)
The fault codes indicate that the monitoring system has detected a serious fault in the machi-
ne or in the current wash program. All fault codes in the supervisory system must be acknow-
ledged on the washer disinfector’s control panel. The fault must be put right by an authorized
service technician. When the fault is put right, the fault code is reset automatically.
The following fault codes may occur:
F00 Faulty temperature sensor (controlling) in wash chamber.
F01 Faulty temperature sensor (independent) in wash chamber.
F02 Incorrect pressure from circulation pump.
F04 Faulty temp sensor in wash chamber. (sensor fault)
F05 Low pressure from circulation pump.
F06 High pressure from circulation pump.
F08 Not enough detergent 1 dosed.
F09 Not enough detergent 2 dosed.
F10 Not enough detergent 3 dosed.
F11 Not enough detergent 4 dosed.
F13 High conductivity.
F14 Incorrect disinfection time.
F15 Disinfection temperature lower than set temperature.
F16 Fault message from the system
F17 Power failure, emergency stop
Fault code Description

Getinge 86 SERIES Specifications

General

Brand	Getinge
Model	86 SERIES
Category	Cleaning Equipment
Language	English