Introduction
Manual 20790, Rev. C, November 1998 1-5
Trigger Delay
Range: 0 to 200 ms, using either the Data Entry keyboard or the spin
knob
Resolution: 0.1 ns
Accuracy: 0to10ms,±0.2%±1ns;10msto5ms,±0.1%;5msto
200 ms, ±0.01%
Triggering Modes
Internal:
-20dBmto+16dBmlimitedto>2dBand<20dBbelowthepeak
level of the signal.
Duty Cycle: <50%
Trigger Rate:
10 Hz to 10 MHz
External:
TTL levels, Max PRF = 1 MHz
Graph Display Mode
Plots the outline of the detected pulse on the EL display. Also
provides readout of amplitude and timing information.
Fast Measurement Mode
Available under GPIB control to provide fast data acquisition and
output.
For an averaging number = 1, typically will be between 70 and
120 measurements/second.
Also can be used to provide fast data acquisition and throughput
via a rear panel analog output for using an 8500A with a network
analyzer to make swept frequency response tests.
Calibrator Specifications
Frequency:
1GHz±5%
Power Uncertainty at 1mW:
±1.5%
Return Loss at 1 mW:
Greater than 25 dB
Self Calibration Time:
Less than 1 minute
Connector: Type N
To Next Page
Loading...
