To Next Page

To Previous Page

Appendix

- 80 -

DeletetheRAIDArray:

To deleted the existing array, press <Enter> on the RAID tab and select Delete VD. When the DeleteVD menu

appears, press <Enter> on the array to select it and then press <Enter> on NEXT. When prompted, press <Y> to

confirm (Figure 10).

When the message "Do you want to delete the VD's MBR?" appears, press <Y> to clear

the MBR or press other keys to ignore.

Figure 10

UsetheMarvellStorageUtilityintheOperatingSystem:

With the Marvell Storage utility, you can set up an array or view the current array status in the operating system.

To install the utility, insert the motherboard driver disk, then go to ApplicationSoftware\InstallApplication

Software and select MarvellStorageUtility to install. Note: After the installation, you must login the utility

with the same account name and password that you use to login the operating system. If you did not set

the account password before, click Login to enter the Marvell Storage Utility directly. Please note that if you

set the hard drive(s) to IDE or AHCI mode, it is normal that you will not see the hard drive(s) in the Marvell

Storage Utility.

[ Adapter] [ Devices]

[ RAID ]

Delete the VD?[Y]

RAID Cong

ID Name Size Level Status Stripe CacheMode

* 0 GBT 152.4GB RAID0 ONLINE 64KB WriteBack

Delete VD

Gigabyte GA-X79S-UP5 User's User Manual

Questions and Answers: