The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
B.ConfiguringSAScontrollermodeinBIOSSetup
Make sure to configure the SAS controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). To
create RAID, set SASController under the Peripherals menu to Enabled (Figure 1).
Step 2:
Save changes and exit BIOS Setup.
Figure 1
To Next Page
Loading...
