Gigabyte GA-Z87X-OC - Page 64

Conguring SATA Hard Drive(s)
- 64 -
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
B. Conguring SATA controller mode in BIOS Setup
Make sure to congure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Go to
Peripherals\SATA Conguration, make sure SATA Controllers is enabled. To create RAID, set SATA Mode
Selection to RAID (Figure 1). If you do not want to create RAID, set this item to IDE or AHCI.
Step 2:
If you want to congure UEFI RAID, follow the steps in "C-1." To enter the legacy RAID ROM, save the settings
and exit BIOS Setup. Refer to "C-2" for more information.
Figure 1