EasyManua.ls Logo

Gigaset E310 - Page 61

Gigaset E310
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
59
Service Centres (Midde East)
Gigaset E310/E310A (Panther) / MEA EN / A31008-M2301-A601-1-UZ19 / appendix.fm / 11.05.2012
Version 5, 03.04.2011
You cannot hear a ringer/dialling
tone from the fixed line.
The phone cord supplied has not
been used or has been replaced by
a new cord with the wrong pin con-
nections.
¤ Please always use the phone cord
supplied or ensure that the pin
connections are correct when
purchasing from a retailer
(¢ page 63).
Each incoming call resets the date/
time incorrectly.
The date and time are sent via e.g.,
your network provider, a router or
PABXs during calling line display.
This data may be incorrect.
¤ Set the date/time correctly e.g.,
on the router or PABX.
¤ Do not automatically copy the
date/time ¢ page 17.
The connection always terminates
after approx. 30 seconds.
Repeater activated/deactivated
(¢ page 50).
¤ Activate/deactivate the handset
(¢ page 20).
When you try to activate Eco Mode
/ Eco Mode+, "Not possible!"
appears in the display.
¤ A handset is registered to the
base that does not support Eco
Mode+.
¤ You use a repeater. Eco Mode /
Eco Mode+ and repeater support
cancel each other out.
Error tone sounds after system PIN
prompt.
You have entered the wrong system
PIN.
¤ Reset the system PIN to 0000
(¢ page 50).
Forgotten system PIN.
¤ Reset the system PIN to 0000
(¢ page 50).
The other party cannot hear you.
You pressed the mute key v dur-
ing a call. The handset is "muted".
¤ Unmute the microphone
(¢ page 28).
The number of the caller is not dis-
played although CLIP has been
set.
Calling Line Identification is not
enabled.
¤ The caller should ask the net-
work provider to enable Calling
Line Identification (CLI).
Refer to the notes on calling line dis-
play (¢ page 27).
You hear an error tone when key-
ing an input.
Action has failed/invalid input.
¤ Repeat the process.
Read the display and refer to the
user guide if necessary.
You cannot listen to messages on
the network mailbox.
Your PABX is set to pulse dialling.
¤ Set your PABX to tone dialling
(¢ page 51).

Table of Contents

Other manuals for Gigaset E310

Related product manuals