Gigaset E490 - Repeater Support Activation; Restoring Base Station to Factory Settings

55
Base station settings
Gigaset E490/E495 / AUS / A31008-M2105-C401-2-7619 / registr_sett.fm / 04.01.2011
Version 4, 16.09.2005
Repeater support
With a repeater you can increase the range
and reception strength of your base station.
You will need to activate repeater mode. This
will terminate any calls that are in progress at
the time.
Precondition: A repeater is registered. The
Eco Mode / Eco Mode + is deactivated.
v
¢ Ð ¢ Base ¢ Add. Features
¢ Repeater Mode
§Yes§ Press the display key.
When repeater mode is active, the menu
item is marked with .
Restoring the base station to
the factory settings
When the settings are restored:
u handsets are still registered
u the system PIN is not reset
v ¢ Ð ¢ Base ¢ Base Reset
~ Enter the system PIN and
press
§OK§.
§Yes§ Press the display key.
Cancel the restoring process by pressing
a or the display key
§No§.
a Press and hold (idle status).
Please note
Repeater support and Eco Mode/Eco
Mode + (
¢ page 44) cancel each other
out, i.e. both functions cannot be used at
the same time.
‰