Gigaset E490 - Connecting the Base Station to the PABX; Connecting Base Station to PABX; Saving Access Code (Outside Line)

56
Connecting the base station to the PABX
Gigaset E490/E495 / AUS / A31008-M2105-C401-2-7619 / pabx.fm / 04.01.2011
Version 4, 16.09.2005
Connecting the base
station to the PABX
The following settings are only necessary
when your PABX requires them; see the PABX
user guide.
You cannot send or receive SMS messages
on PABXs that do not support Calling Line
Identification.
Recall
The current setting is indicated by .
Setting recall
Your phone is preset at the factory for oper-
ation on the main connection. For operation
on a PABX, you may have to change this
value. Please refer to the user guide for your
PABX .
v
¢ Ð ¢ Base ¢ Add. Features
¢ Recall
s Select recall and press §OK§
( = set value). Possible values
are:
80 ms, 100 ms, 120 ms, 180 ms,
250 ms, 300 ms, 600 ms, 800 ms.
a Press and hold (idle status).
Saving an access code
(outside line code)
Precondition: You may have to enter an
access code for external calls in your PABX,
e.g. "0".
v
¢ Ð ¢ Base ¢ Add. Features
¢ Access Code
~ Enter or change access code,
max. 3 digits.
¤ Save the changes.
If an access code has been saved:
u The access code is prefixed automatically
when you select from the following lists:
numbers of the SMS centres, calls list or
answering machine list.
u The access code must be entered when
dialling manually and when manually
entering directory, emergency/shortcut
numbers and SMS centre numbers.
u If you copy the recipient's number from
the directory when sending an SMS, you
have to delete the access code.
u An existing access code is deleted
using X.
‰
‰