•
Keeping the flywheel connector rubber
clamp on the coolant inlet hose, refit
the flywheel cover paying attention in
inserting the strap in the groove.
•
Tighten the 4 studs, noting that the two
longer golden screws are inserted in
the 2 top holes and are also responsi-
ble for restraining the secondary air-
box.
Flywheel and starting
Removing the starter motor
• Remove the central stand by unscrewing the 3
set screws of the engine support
• Remove the set screws indicated in the figure
DNA 50 Engine
ENG - 77
To Next Page
