Gilera DNA 50 - Page 95

Disassembling the complete fork
- Remove the front wheel.
- Remove the front brake calliper. Take out the
brake hose and the speedometer lead from the
support bracket anchored on the lower plate.
- Remove the handlebar support bracket and bring
the handlebar forward without disconnecting the
drives.
- Loosen the four front cover support screws on the
fork legs.
- Loosen the two pump unit set screws on the up-
per plate, remove ring nut A and pull out the upper
plate.
- Remove ring nut B, extract the rubber protection
and the washer.
- Remove the complete fork from the bottom being
careful to support the cover only with the brackets
anchored to the fork legs.
- Use the extractor to remove the bearing from the
seat in the chassis.
- Remove the roller bearing and sealing ring of the
lower plate
See also
Front
brake calliper
Handlebar
DNA 50 Suspensions
SUSP - 95