41
Issue: 8 (Applies to firmware 2387 6.09 onwards)
Document number: 1390-PS-0039
Prepare Connector Head (Gill Part 020-04464).
Remove the connector thread protector and place the O-ring (part 7) into the groove of the connector head (020-04464).
Assemble Connector to the Cable
Referring to Page 40 and Page 43 push connector contacts through the red connector head seal into the appropriate
location, when in place there should be a click as the contact locks into position.
Once contacts are in position pass part 6 up the cable and into position as shown below.
Note: if a connector pin needs removing use Cannon Extraction Tool, Manufacturer’s Part 192922-1450.
1. Fold and spread screen wires over part 6 and then push up part 5 as shown to clamp screen wires between
Parts 5 and 6.
2.
3. Now screw in part 4 and torque up to a value of 10Nm.
Remove the thread protector
To Next Page
Loading...
