7
Issue: 8 (Applies to firmware 2387 6.09 onwards)
Document number: 1390-PS-0039
3.3. WindObserver Accessories
After you have successfully set up the WindObserver 65, we strongly advise that you then go back and read the rest of
the manual to ensure that you get the best results from the WindObserver 65.
3.4. WindObserver FCC
This product carries the CE and UKCA marks. A copy of the Declaration of Conformity can be downloaded
from www.gillinstruments.com
.
WindObserver 65 complies with part 15 of the RCC Rules. Operation is subject to the following two conditions: -
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Cable 3 Pair twisted and Shielded wires, 24awg, per metre.
Cable 4 Pair twisted and Shielded wires, 24awg, per metre. 026-03156
Cable 9 Pair twisted and Shielded wires, 22awg, per metre.
Gill Bracket Mounting Adaptors
To Next Page
Loading...
