Gill WindObserver 65 - Right to Change and Revise; Packaging; Windobserver Specification; Windobserver Standard Equipment

8
gillinstruments.com
Issue: 8 (Applies to firmware 2387 6.09 onwards)
Document number: 1390-PS-0039
Ultrasonic Anemometer
3.5. Right to change and revise
Gill Instruments reserve the right to change or revise the product without notice or the obligation to notify any person or
organisation of such change or revision.
Gill Instruments reserve the right to change or revise the information supplied in this manual without notice or the
obligation to notify any person or organisation of such change or revision.
The reproduction and distribution of the documentation and software supplied with this product and the use of its
contents is subject to written authorization from Gill Instruments.
3.6. Packaging
Whilst the WindObserver 65 is being moved to its installation site, the unit should be kept in its packaging. Retain the
packaging for use if the unit must be moved or returned to Gill Instruments.
3.7. WindObserver Specification
The WindObserver Specification can be found in Appendix A
3.8. WindObserver Standard Equipment
WindObserver 65 is supplied with:
• Mounting kit & gasket
• Connector kit (if connector base option ordered)
• Base mount (if Base mount option ordered)
3.9. Downloadable Software
Two software packages are available to help customers use the WindObserver 65:
• Wind – this software can be used as a terminal program to set-up the product.
• WindView – this software can be used to view and log data provided by the product.
Both software packages can be downloaded from www.gillinstruments.com