Gill WindObserver 65 - Page 45

45
gillinstruments.com
Issue: 8 (Applies to firmware 2387 6.09 onwards)
Document number: 1390-PS-0039
Ultrasonic Anemometer
WindObserver 65 Default Set-up
Default Settings
The factory default settings are:
Non -
heated units
A0 B3 C1 E1 F1 G0000 J1 K1 L1 M2 NA O1 P1 T1 U1 V1 X1 Y1 Z1 DR0
Plus RWASHORT 10 and RWALONG 60.
Heated units
A0 B3 C1 E1 F1 G0000 H2 J1 K1 L1 M2 NA O1 P1 T1 U1 V1 X1 Y1 Z1 DR0
Plus RWASHORT 10 and RWALONG 60.
That Heating (H command) is enabled as a default condition. If heating is not required enabled then the H
command must be set for H1.
See Section Appendix F Configuring for further details