To Next Page

To Previous Page

Figure 4-3-2-3 Binding SpO2 probe

Figure 4-3-2-4 Placing SpO2 probe

Plug the SpO2 probe into USB interface, as Figure 4-3-2-4.

1) Connect the probe with the device.

2) Put the nger into the probe.

3) In measurement interface,you can directly read corresponding data from dis-

play screen.

Warning: Use the SpO2 probe specied by our company,and other SpO2

probes are forbidden.

Notes:

 Testee’s ngernail shall not too long.

 Testee shall not use enamel or other makeup.

 The nger too cold or too thin may affect the measurement; when measuring,

please insert the thicker nger fully into the probe (thumb or middle nger rec-

ommended).

 In operation, the nger tested shall not tingle and the testee shall not be in

movement.

 When inserting the nger, ngernail and the luminescent tube should be on the

same side

ENGLISH

Gima RS01 User Manual

Other manuals for Gima RS01