1. Spread out the paramotor glider completely on a smooth surface. Do not drag the paramotor
glider across any rough surfaces such as gravel or asphalt. This may damage the seams and
surface coating.
2.-3. All the ribs on one side are placed one on top of one another, so that the leading edges are
not bent.
4. Then continue as in the second step, placing the leading edges of the other side on top of the
next until you reach the tip of the glider. Place the concertina bag underneath the glider
which has been folded together, so that the ribs are all lying along the length of the
concertina bag.
5. The glider is now folded up along its length, and the leading edges are on top of each other
without having being bent.
Fasten the straps near the leading edges, so that they do not slip, and the straps in the
middle and at the end of the glider.
6. Do up the zip, making sure that none of the lines or fabric is caught in the zip.
7. Fold up the glider along its length, with the first fold below the leading edge reinforcements.
Pay particular care not to bend any of the rigid reinforcements!
8. Fold the glider again. Then place the compression strap around the glider and fasten it by
pulling gently. Make sure that the glider is only loosely folded and is not bent or compressed
excessively.
Rucksack
All GIN gliders are delivered with a durable ripstop Codura® rucksack with 160L capacity. The
rucksack should be packed carefully to achieve maximum comfort. First, place the glider inside the
harness and then put the top of harness in the bottom of the rucksack with the glider side next to
the back of the rucksack. Finally, tighten the internal and external compression straps and adjust
the shoulder and waist straps to ensure the equipment stays firmly in place when walking. There
are also two storage pockets for accessories.
An XXL rucksack is available as an optional extra for pilots that require it.
To Next Page
Loading...
