Edit mode 23
Code no. 576017
Rev. nº 02/0415
Programming the cooling-down time
Example: a cooling-down time of 2 minutes.
Increasing the length of the cooling time.
Maximum programmable time: 10 min.
Decreasing the length of the cooling time.
Minimum programmable time: 0 min.
Confirming the cooling time.
Accessing the following screen.
Back to the previous menu.
Very important!
The cooling stage is intended to reduce the temperature inside the drum, thereby preventing creases in
the fabrics and reducing the risk of spontaneous combustion from static electricity.
As a security measure it is highly advisable to program enough time to allow the fabrics to cool.
To Next Page
Loading...
