LOGI CONTROL. Advanced mode 37
Cod. 523340
Rev. 10/1016
Rotation time
Rotation time programmed in the phase. Time in minutes.
This time is started once the programmed temperature and level are reached.
Programmable range in the soak, pre-wash and rinse phases
Programmable range in the wash phase
The ▲/▼ keys allow the user to modify the option displayed.
The key validates the selection on the display and allows the user to access the following programmable
function.
Gradual cool down
The gradual cooling down of the water is achieved by adding cold water until a temperature of 45 ºC (113 ºF) is
reached.
This function will appear only in the wash phase if the programmed temperature is over 50 ºC (122 ºF).
Gradual cool-down deactivated
Gradual cool-down activated
The ▲ key allows the user to modify the option displayed.
The key validates the selection on the display and allows the user to access the following programmable
function.
Rinse hold
All the functions of the washing machine stop, maintaining the water inside, with a light rotation of the drum at
15 minute intervals. This is only programmable in the final phase of the program.
This function is designed to prevent the laundry from remaining for a long time inside the drum, once the final
spin is finished, thus preventing the appearance of creases.
The ▲key allows the user to modify the option displayed.
The key validates the selection on the display and allows the user to access the following programmable
function.
Bath drain
The draining of the water from the washing machine is achieved by activating of the drain system and a drum
rotation speed.
Option E-1 implies an unchangeable time value. The duration of options E-2 – E-6 is programmable within a
determined range.
Access to the next phase without draining in the bath
Drain + positioning speed
Drain + low extract speed
Drain + medium extract speed
Drain + medium/high extract speed
Drain + high extract speed
Only programmable in the final phase of the program
To Next Page
Loading...
Need help?
General
