Page 13
Operating Instructions
Knife is still rotating even though chute has stopped.
La lame est encore en rotation bien que le plateau porte-produit est à l’arrêt.
8. To turn slicer completely off and stop knife, press stop button. If auto engage lever has not already been returned
to “Manual” position, push down or lower lever to “Manual” position.
9. Using food chute handle, pull food chute all the way towards you. Turn slice thickness dial clockwise past
zero (0) until it stops, closing slicer table. Now you can load and unload food product from food chute.
10. When nished using slicer, make sure slicer is turned off, slice thickness dial is turned clockwise
past 0 until it stops and auto engage lever is in “Manual” position.
AUTOMATIC SPEED SETTINGS
Model # Chute Speed Setting Strokes Per Minute
3850N L (low-normal) 40
H (high-faster) 60
3975N 1 20
2 28
3 32
4 38
5 40
6 50
7 52
8 58
9 60
Note: Strokes per minute may vary +/- 10%.
MANUAL OPERATION on an AUTOMATIC SLICER
ALWAYS make sure auto engage lever is in the “Manual”
position before turning slicer on (Fig. 13-1).
1. Automatic slicers can be used manually when desired.
2. When manually operating an automatic slicer in “Manual” mode, auto
engage lever MUST be in “Manual” position before turning slicer on.
Lever should not be moved out of “Manual” position at any time during use.
3. Follow instructions on page 12 through 13, skipping steps 6 and 7,
which have to do with activating auto engage lever for automatic
slicer operation.
Figure 13-1
Auto Engage Lever
To Next Page
Loading...
Need help?
General
