Page 9
Installation and Proper Grounding
Figure 9-3 Correct
Figure 9-4 Incorrect
THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE OUTLET TO WHICH
THIS PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE RECEPTACLE IS NOT THE
PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN. DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD GROUND PRONG FROM THE POWER CORD OR USE ANY ADAPTER
PLUG (Figure 9-3 and Figure 9-4).
9. Make sure warning labels are properly positioned and legible and instruction manual is available near slicer.
Place Spanish labels on slicer if required.
10. Complete warranty registration online at www.globefoodequip.com/support/warrenty-registration-form.
11. Post provided wall chart in a visible area near slicer to be referred to often for cleaning, sanitizing, and
inspecting your slicer. Refer to wall chart and the Owner’s Manual for proper cleaning, sanitizing and
inspection of your slicer.
12. Clean slicer using the procedures outlined in cleaning section (pages 14 through 18) prior to using slicer.
13. Contact your local representative, or Globe directly, if you have any questions or problems with installation or
operation of slicer.
To Next Page
Loading...
Need help?
General
