Mirror Operation
The right side
of
the switch located at the bottom of the
mirror turns the electrochromic mill-or on
and
off. The
AUTO
LED
will
come on when the electrochromic mirror
is turned on.
To
turn
the mirror on, press and hold the
MIRROR button for three seconds. The mirror
will
darken
and remain dark
until
the button
is
released. To turn the
mirror
off,
press and release the MIRROR button.
Compass Operation
Press
COMP
to
turn the compass
on
or
off.
When
the
ignition
and
the compass feature
are
011.
rne
compass
will
show two character boxes for
approximately two seconds. After
two
seconds, the
mirror will display the compass heading.
When cleaning the mirror, use
a
paper towel or similar
material dampened
with
glass cleaner.
Do
not spray
glass cleaner directly on the mirror as that may cause the
liquid cleaner to enter the mirror housing.
Compass Calibration
If
after two seconds the display
does
not show a
compass heading
("N"
for North,
for
example), there
may be a strong magnetic field interfering
with
the
compass. Such interference
may
be caused by
a
magnetic antenna mount, magnetic note pad Imlder or
a
similar magnetic item.
If
the letter
"C"
should ever
appear
in
the compass window, the mirror may
need calibration.
The mirror can be calibrated
in
one
of
two
ways:
0
Drive the vehicle
in
circles at five
mph
(8
kmh) or
less
until
the display reads
a
direction,
01-
0
Drive the vehicle on your everyday routine.
2-45
To Next Page
Loading...
