GMC 1997 Suburban - Front Parking;Turn Signal Lamps with Sealed Beam Headlamps

3. Unplug the
electrical connector.
4. Turn the bulb to the left and remove it.
5. Put the new bulb into the lens assembly and turn it to
the right until it is tight.
6. Plug in the electrical connector.
7. Put the headlarnp lens assembly back into the
vehicle. Install and tighten the two screws.
Front Parking/Turn Signal Lamps with
Sealed Beam Headlamps
1
Remove the two screws
at the inside edge
of
the parkinghrn signal
lamp assembly.
2. Remove the lamp assembly by swinging it out from
the inside edge and sliding it out at the outside edge.
6-39