Using the Alarm
U
(Alarm): The alarm on the radio can be used
to activate an alarm at a desired time.
To set the alarm, perform the following:
1. Press the
U button until the alarm symbol
displays.
2. Press the
U button again until the display
flashes.
3. Press the up tuning arrow to change the hour.
4. Press the down tuning arrow to change the
minutes. After setting the alarm, the display
changes back to the current time.
5. Press the alarm button, again and the alarm
symbol displays. The alarm sounds at the
same time every day.
6. To turn the alarm off, press the
U button.
7. To deactivate the alarm, press the
U alarm
button.
To check the time of the alarm, press
the
U button.
Playing a Cassette Tape
The tape player is built to work best with tapes
that are up to 30 to 45 minutes long on each side.
Tapes longer than that are so thin they may not
work well in this player. The longer side with
the tape visible should face to the right. If you hear
nothing or hear a garbled sound, the tape might
not be in squarely. Press the
Y (eject) button to
remove the tape and start over.
If the ignition is on and the radio is off, the tape
can be inserted and begins playing.
While the tape is playing, use the VOL, TONE,
and BAL controls just as you do for the radio.
The radio displays an arrow to show the
tape direction. The tape player plays the other
side of the tape when it reaches the end.
The tape bias is set automatically when a metal or
chrome tape is inserted.
r PR / [ OG (Fast Forward/Reverse): Press
either arrow to either fast forward or reverse the
tape, depending on the direction of the tape as
indicated on the display. To stop fast forwarding
or reversing, press the other arrow.
144
To Next Page
Loading...
Need help?
General
