SECTION VIID CANDI MODULE
2005 Tech 2 User’s Guide VII - 70
CANdi Module Software Updates
Software updates for the CANdi module are stored on the 32-megabyte PCMCIA card. The CANdi module
will be automatically updated when it is connected to the vehicle’s DLC and the Tech 2 is powered on.
When a CANdi module is updated, the screen shown in Figure VI-25 will be displayed. Software update
progress will be displayed on the Tech 2 screen. If any problems occur concerning the update, they will be
displayed on the Tech 2. (Refer to Section VI - Troubleshooting.)
After a successful update, the current CANdi software version can be obtained by selecting:
F9: CANdi Diagnostics - from the Tool Options menu (Figure VI-29)
F0: POST Results - from the CANdi Diagnostics menu (Figure VI-30)
The CANdi POST Results screen (Figure VI-31) can also be used to determine if the module had any
problems during the software update or start-up sequence. Customer Support may also use the
information from the CANdi POST Results screen, if you encounter any problems during an update.
The latest CANdi software version will be included in TIS software and will be automatically downloaded to
the PCMCIA card during a software update. Make sure you have the latest version of TIS software on your
terminal.
IMPORTANT
You must update the PCMCIA (32-megabyte) card first before connecting the CANdi module to the
Tech 2. Always disconnect the CANdi module from the Tech 2 before downloading any software
updates to the PCMCIA card.
The CANdi module has the capability to store three different software versions.
To Next Page
Loading...