SECTION III GETTING STARTED
2005 Tech 2 User’s Guide III - 3
PCMCIA Card Removal
The PCMCIA Card is accessed by opening the hinged door located at the top of the Tech 2. The card is
found in the upper slot. The lower slot will be used for future enhancements. Press the arrow button
(located beside the slot) to eject the card (Figure III-8).
Figure III-8
Ejection of PCMCIA card
NOTICE
Use only GM Service and Parts Operations supplied PCMCIA cards. The PCMCIA slots are designed
to interface with 5-volt cards. Permanent damage to Tech 2 could occur if a 3.3-volt card is inserted into
the Tech 2 PCMCIA connector.
PCMCIA Card Insertion
The PCMCIA Card is keyed with two notches on one side and one notch on the other side (Figure III-9).
Make sure that the notches are in the correct position before inserting the card. Slowly insert the card
(Figure III-10) until it clicks into place.
Figure III-9
PCMCIA card keying
Figure III-10
PCMCIA card insertion
To Next Page
Loading...