25
TX6160 INSTRUCTION MANUAL
To select a CTCSS or DCS code:
1. Select the required channel.
2. Press and hold the Menu key until the radio beeps. ‘CT’ (for CTCSS) or ‘DT’ (for DCS) will be
displayed.
3. Press the or keys to select the required tone/code.
4. To select CTCSS tones 01 to 50 press the or keysys while ‘CT’ is displayed. When a
CTCSS code is selected the icon is displayed.
5. To select DCS codes, hold the or keys to scroll past CTCSS tone 50 until ‘DT’ is
displayed. Now use the or keys to select the required DCS code 001 to 104. When a
DCS code is selected the icon is displayed.
6. To return to CTCSS tones hold the or keys until ‘CT’ is displayed again.
7. To turn the CTCSS/DCS tones o, hold the or keys to step to the end of the code list
until oFF is displayed.
8. Press the PTT switch to conrm and store your selection. The (CTCSS) or (DCS) icon
remains on the display to conrm the code system you have selected.
To enable Silent Mode on a channel:
1. Select the required channel.
2. Press and hold the SQL key for about 2 seconds. The selected code number will be displayed
on that channel.
3. The selected channel will now remain silent unless a signal is received containing the chosen
code.
Note: Silent mode will only be enabled on channels you select. Other channels will remain open to all
incoming signals.
To disable silent mode on a channel:
1. Select the required channel. The CTCSS/DCS code will be displayed.
2. Press and hold the SQL key for about 2 seconds. The selected code number will disappear
from the display on that channel. The selected channel will now be open to all incoming
signals.
To Next Page
Loading...
