GME TX6160X - Transmitter Power and Compander

TX6160 INSTRUCTION MANUAL
26
TRANSMITTER POWER
The transmitter power can be set to High or Low. The power setting option applies to all channels
(except 5/35).
To set the transmit power:
1. Select the required channel.
2. Press and hold the Menu key until the radio beeps.
3. Briey press the Menu key repeatedly until ‘PW’ is displayed. ‘Hi’ or ‘Lo’ will be ashing.
4. Press the or keys to select the required power setting. Select ‘Hi’ for high power or
‘Lo’ for low power.
5. Press the PTT switch to conrm and store your selection.
The radio should now display the selected channel number along with the Hi or Lo icon to indicate the
transmit power you have set on that channel.
COMPANDER FUNCTION
The radio is equipped with an Audio Compander, designed to reduce extraneous background noise.
When utilising the Compander there are two settings available, on and Auto (AUt). When set to ‘On’
the Compander will operate both with and without an earpiece or speaker microphone connected to
the radio. When set to ‘Auto’ mode the Compander will operate only when an earpiece or speaker
microphone is connected to the radio and the receive audio and beep tone volume levels are
automatically reduced.
To enable or disable the compander:
1. Select the required channel.
2. Press and hold the Menu key until the radio beeps.
3. Briey press the Menu repeatedly until ‘CP’ is displayed. The CP icon will be ashing.
4. Press the or keys to select ‘on/ AUt’ or ‘oFF’.
5. Press the PTT switch to conrm and store your selection.
When the Compander is operating, CP will be displayed on the LCD.