4-4
USER HANDBOOK
4.2.2 Sample Inlet Filter
1. Using a No.1 Pozidrive
®
screwdriver, remove the two
retaining screws, then remove the sample line connector.
RETAINING SCREWS
Fig. 4.3 Sample Line Connector
2. Push the sample inlet lter out.
3. Fit a new Sample Inlet Filter (Part No. 66084).
4. Replace the sample line connector. The sample line
connector is moulded to t in one direction only.
5. Replace the two retaining screws.
Note: Do not over-tighten the screws.
To Next Page
Loading...
