GN Danalogic Ambio BRIE - Daily Maintenance; Brush (Optional); Cleaning Earmoulds

1
2
3
28 29
11 Daily maintenance
It is important to keep your hearing aid clean and dry.
On a daily basis, clean the hearing aids using a so cloth or ssue.
If the microphone inlets are clogged, gently brush across the microphone
inlets with a small, clean brush.
i
NOTE: Do not use force to press the hairs of the brush into the
inlets, because the microphones may be damaged
NOTE: Do not use alcohol or other solvents to clean your hearing
aids; the protecve coang will be damaged.
11.1 Brush (oponal)
Use the three-in-one brush for daily cleaning and baery handling.
1. Brush - cleaning: Use the brush on all surfaces and orices
2. Wire loop - cleaning: Use the wire loop to clean the earmould
3. Magnet - baery handling: Use the magnet to li and replace the
baery
i
NOTE: Do not use the wire loop to clean the microphone openings.
If the micro-phone openings clog up, visit your hearing care
professional.
NOTE: The wire loop is only intended for BTE earmoulds.
11.2 Cleaning earmoulds
1. Detach the earmold and tubing from the hearing aid before cleaning
2. Use a mild soap to clean the earmould and rinse with lukewarm water
3. Dry the earmould thoroughly. Use the airbulb and cleaning wire to
remove residual water and debris from the tubing.
i
NOTE: Earmould tubing may become s, brile, or discoloured
over me. Contact your hearing care professional regarding tube
changes.