Goblin FIREBALL - Page 28

Page 27
Chapter 19, Spare Parts
- 2 x Main Blade 280mm.
- 1 x Left Tensioner Support.
- 1 x Column Tensioner.
- 1 x Tensioner.
- 1 x Flat Cap Screw M2.5x5.
- 2 x Flanged Bearing 4x7x2.5.
- 1 x Special Screw M2.5x6.
- 2 x Wire Positions.
- 2 x Self Tapping
Screw M2.2 x 6mm.
- 1 x RX Support.
- 1 x Double Side Tape.
- 1 x Tail Shaft.
- 1 x Set Screw M2.5x4mm.
- 1 x Set Screw M3x4mm.
- 1 x Feeder.
- 1 x Feeder Damper.
- 1 x Set Screw M3x4mm.
- 1 x Main Plate.
- 2 x Nylon Nut M3.
- 1 x Bearing Support.
- 2 x Bearing
Ø4.765xØ12.7x4.987. - 1 x Frame DX Assembled. - 1 x Frame SX Assembled.
- 1 x Yellow Canopy.
- 2 x Button Cap Screws M3x4.
Main Blade 280mm
(280TB)
Left Tensioner Support
(H0870-S)
Wire Positions
(H0858-S)
Tail Shaft
(H0842-S)
Feeder
(H0839-S)
Main Plate
(H0838-S)
Bearing Support
(H0837-S)
Frame DX
(H0833-S)
Frame SX
(H0832-S)
Canopy
(H0831-S)
Pulley 76T
(H0820-S)
Front Servo Support
(H0819-S)
- 1 x Pulley 76T.
- 1 x Button Cap Screws M2x4.
- 1 x Front Servo Support.
- 1 x Rear Servo Support
- 2 x Socket Cap Screws M2x6.
- 2 x Socket Cap Screws M2x8.
Canopy Positioner
(H0844-S)
- 2 x Canopy Positioner.
- 2 x Button Cap Screws M3x4.
Right Tensioner Support
(H0899-S)
- 1 x Right Tensioner Support.
- 1 x Column Tensioner.
- 1 x Tensioner.
- 1 x Flat Cap Screw M2.5x5.
- 2 x Flanged Bearing 4x7x2.5.
- 1 x Special Screw M2.5x6.