Gocycle
®
Owner’s Manual for G2, August 2015
© Karbon Kinetics Limited. All Rights Reserved. 47
7 MAINTENANCE AND ADJUSTMENTS
7.1
Maintenance and Service Centre Location
In the event that you require maintenance and service please refer to your nearest authorized Gocycle
service center. A list of approved service centers can be found at www.gocycle.com. Before
attempting any maintenance on your Gocycle you must visit www.gocycle.com/safety for up to date
important safety related information.
7.2
Service interval
Recommended Service Interval
Authorised Gocycle
Reseller
After first 100
miles/160 kms
2 months after
first ride
Visit www.gocycle.com/safety
Check and Update to latest
Firmware Version
Authorised Gocycle
Reseller
Every 2000
miles/3200 kms
7.3
Cleaning and Preventing Corrosion
We do not recommend that you ride your Gocycle in heavy rain or store it in damp or wet areas.
Please read 2.7 Riding in Wet, Cold or Icy Conditions for safety recommendations for riding in wet
conditions.
If you do find yourself riding while it is raining, we recommend that you use the motor when safe to
do so. Using the motor will allow heat to build up in the motor and the electronics, which will
evaporate the water from these moisture-sensitive components. Use caution when you use the motor
on wet roads, as the roads will be slippery and the motor may cause the front wheel to spin.
Water and moisture (especially spray from roads that are salted to reduce the formation of ice) can
accelerate corrosion (rust) of the various metallic components on the Gocycle, and this will reduce the
life of product. Leaving water and moisture on the Gocycle could also result in premature failure of
the electronics, battery or motor system. The warranty will not cover premature failure as a result of
corrosion through neglect.
Here are some best practice recommendations:
To Next Page
Loading...
