Gocycle G2 - Tyres

Gocycle
®
Owner’s Manual for G2, August 2015
© Karbon Kinetics Limited. All Rights Reserved. 71
7.8.3 Fleet management and Tour Operators
If you operate a fleet of Gocycles that are lent to people who are not accustomed to the Gocycle or are
running a tour operating service with the Gocycle as the chosen vehicle we would highly recommend
fitting the tamper proof security bolts. This prevents tampering and reduces the chances of novice
users from making a mistake when assembling the product that could potentially make it unsafe to
ride.
If there is a requirement to fold the Gocycle and remove the wheels during use then the importance of
the pre ride checklist must be taught to the operator of the Gocycle. Furthermore, all Gocycles must
be PDI’d with cam lever adjustments completed before each and every handover to the tourist/ fleet
user.
7.9 Tyres
Gocycle comes fitted as standard with specialised, high-performance tyres designed to give the best
combination of low rolling resistance, light weight and puncture resistance. To maximise
performance, we do not recommend that you use lower quality tyres than those supplied with
Gocycle.
We recommend that you operate Gocycle with tyre pressures of 25–30 psi on the front and 40–50 psi
on the rear. This will give the best balance of low rolling resistance and comfort. Running a relatively
softer front acts as a “cushioning effect”, reducing shock loads to the motor fork components—
specifically the clutch and gearbox.
We do not recommend that you inflate the tyres to more than 60 psi. Inflation pressures greater than
60 psi will reduce comfort and the service life of the product.
WARNING! Inflating the front tyre to more than 30 psi places high shock loads into the motor drive
system (motor, gearbox and clutch) whilst using the power on acceleration or over rough roads. Just
like in a car as you would not accelerate rapidly on very rough roads, do not use motor power when
going over potholes or speed bumps or similar obstructions in the road.
Operating the Gocycle with a front tyre pressure greater than 30psi and/or using the motor assistance
on rough terrain, against these recommendations, will invalidate the warranty.
Whilst the Gocycle’s front and rear PitstopWheel is easily interchangeable, ensure that you place the
lower-pressure tyre on the front during assembly.
When changing a tyre, always use plastic tyre levers. Never use a metal tyre lever as you will damage
the wheel rim.
Note the correct direction of the tread of the Gocycle tyre in relation to the wheels (see figure below).
In the event that you wish to use a lower performance tyre with increased puncture resistance, you
can use any BMX-sized tyre (406x40-47) from 1.75" to 2". Ask a retailer for a recommendation for a
suitable alternative.
WARNING! Bicycle tyres do not last forever. When the tread depth is critically low and the centreline
grooves in the tyre have worn down in any part of the tyre, it may be dangerous to continue to ride
on the tyre, and in this event, we recommend that you replace the tyre.